Jeep Wrangler Unlimited 2014 Owner's Manual

It's recommended to change the oil every 5,000 to 7,500 miles, depending on your driving conditions. Always refer to your owner's manual for the most accurate intervals.

The 2014 Jeep Wrangler Unlimited typically uses 5W-20 synthetic oil, but you should verify with your owner's manual or dealership for any specific requirements.

To reset the TPMS, fill all tires to the recommended pressure, drive the vehicle above 15 mph for at least 10 minutes, and the system should reset. If it doesn't, consult your dealer.

The recommended tire pressure for the 2014 Jeep Wrangler Unlimited is typically 35 PSI for both front and rear tires, but you should check the placard located on the driver's side door jamb.

To improve fuel efficiency, maintain proper tire pressure, reduce excess weight, drive at steady speeds, and keep up with regular maintenance like oil changes and air filter replacements.

If the check engine light comes on, check for loose gas caps first. If the light remains, use an OBD-II scanner to check for trouble codes or visit a mechanic for diagnosis.

To replace the air filter, open the hood, locate the air filter housing, unclip the cover, remove the old filter, and insert the new filter. Make sure the new filter is seated properly before securing the cover.

Check the transmission fluid level by warming up the engine, parking on a level surface, and using the dipstick located under the hood. The fluid should be within the marked range on the dipstick.

The towing capacity of the 2014 Jeep Wrangler Unlimited is up to 3,500 pounds, depending on the model and equipment. Ensure your vehicle is properly equipped before towing.

To pair your phone, ensure Bluetooth is enabled on your device, press the 'Phone' button on the vehicle's audio system, and follow the prompts to connect. Enter the required passkey if prompted.