Jeep Compass 2008 Owner's Manual
![Jeep Compass 2008 SUV manual cover](/images/GAKzjZKbqtmRUslLcWKaTHEj/thumbs/thumb175x175.webp)
To reset the oil change light, turn the ignition to the "ON" position without starting the engine. Fully depress the accelerator pedal slowly three times within 10 seconds. Turn the ignition off and then start the engine to verify the indicator has been reset.
The 2008 Jeep Compass typically requires 5W-20 synthetic motor oil. Always refer to the owner's manual for the most accurate information.
First, check the A/C fuse and relay in the fuse box. Ensure that the refrigerant levels are adequate. Inspect the A/C compressor and clutch for signs of wear or damage. If issues persist, consult a professional technician.
If the battery is new, check the starter, ignition switch, and alternator. Ensure all connections are clean and tight. A faulty key fob or immobilizer system could also be the issue.
The recommended tire pressure for the 2008 Jeep Compass is typically 32 PSI for both front and rear tires. Always check the sticker on the driver's side door jamb for the most accurate information.
The 2008 Jeep Compass uses a timing chain instead of a timing belt, which generally does not require regular replacement. However, it's crucial to maintain regular inspections.
Common causes include low coolant levels, a faulty thermostat, a malfunctioning radiator fan, or a leaking radiator. Regular maintenance can help prevent these issues.
First, ensure the vehicle is on a flat surface and apply the parking brake. Loosen the lug nuts slightly, jack up the vehicle, and remove the lug nuts completely. Replace the flat tire with the spare, tighten the lug nuts, lower the vehicle, and fully tighten the lug nuts in a crisscross pattern.
The 2008 Jeep Compass has a towing capacity of up to 2,000 pounds when properly equipped. Always consult the owner's manual for specific towing guidelines.
Locate the cabin air filter housing behind the glove box. Remove the glove box by detaching the damper and squeezing the sides. Open the filter housing, slide out the old filter, and replace it with a new one, ensuring the airflow direction is correct. Reassemble the glove box.