Jeep Compass 2018 Owner's Manual

To reset the oil change indicator, turn the ignition to the "On" position without starting the engine. Fully depress the accelerator pedal slowly three times within 10 seconds. Turn the ignition off and then start the engine to verify the indicator has been reset.
The 2018 Jeep Compass typically uses SAE 0W-20 full synthetic motor oil. However, it's best to consult the owner’s manual or a certified dealer for the most accurate information.
To improve fuel efficiency, ensure regular maintenance, keep tires properly inflated, use recommended fuel, drive at consistent speeds, and remove excess weight from the vehicle.
If the battery dies, you can jump-start the vehicle using jumper cables and another car. Connect the positive and negative terminals correctly, start the assisting car, and then start your Compass. Let it run for a few minutes before disconnecting.
To pair your phone, turn on Bluetooth on your phone, press the 'Phone' button on the Uconnect system, and follow the prompts to add a device. Select your phone from the list and confirm the pairing code on both the system and the phone.
Common causes include a loose gas cap, faulty oxygen sensor, bad spark plugs, or issues with the catalytic converter. It's advisable to diagnose the specific code using an OBD-II scanner.
It's recommended to rotate the tires every 6,000 to 8,000 miles to ensure even wear and extend tire life. Regular rotation helps maintain optimal handling and performance.
The recommended tire pressure for the 2018 Jeep Compass is typically 32 psi for both front and rear tires. Always refer to the placard on the driver’s side door jamb for the most accurate information.
To replace the headlight bulb, open the hood and locate the back of the headlight assembly. Remove the power connector, twist the bulb counterclockwise, and pull it out. Insert the new bulb, twist it clockwise to secure, and reconnect the power connector.
If the vehicle overheats, turn off the air conditioning and turn on the heater to its maximum setting. Pull over safely, turn off the engine, and allow it to cool. Check coolant levels and for leaks once the engine is cool. Seek professional assistance if necessary.