Jeep Cherokee 2020 Quick Reference Guide
![Jeep Cherokee 2020 SUV manual cover](/images/dbdFRPdPuQUKRcOVTqDLwJqa/thumbs/thumb175x175.webp)
To reset the oil change light, turn the ignition to the "ON" position without starting the engine. Fully depress the accelerator pedal three times within 10 seconds. Turn the ignition off and then start the engine to confirm the reset.
The 2020 Jeep Cherokee typically requires SAE 5W-20 or SAE 5W-30 engine oil. Always refer to the owner's manual for the correct specification.
To connect your phone, enable Bluetooth on your phone and the Uconnect system. Select "Phone" on the Uconnect screen, then "Pair Device." Follow the prompts to complete the pairing process.
The recommended tire pressure for the 2020 Jeep Cherokee typically ranges from 32 to 36 PSI. Check the placard on the driver's side door jamb for exact specifications.
The Jeep Cherokee uses an automatic system to engage four-wheel drive. You can select different terrain modes using the Selec-Terrain dial to optimize performance based on driving conditions.
The 2020 Jeep Cherokee typically does not have a dipstick for transmission fluid. Checking or servicing the transmission fluid should be performed by a qualified technician.
If your engine overheats, turn off the air conditioning and turn on the heater to its maximum setting. Pull over safely, turn off the engine, and allow it to cool before checking coolant levels or seeking professional help.
The air filter should be checked every 12,000 to 15,000 miles and replaced as needed, or according to the intervals specified in the owner's manual.
Common causes include a loose gas cap, faulty oxygen sensor, or issues with the catalytic converter. It's advised to get a diagnostic scan to identify the specific problem.
To perform a factory reset, press the 'Settings' button on the Uconnect display, then select 'Reset' and follow the prompts to complete the process. Ensure to back up any important data first.