Husqvarna T50 RS 965896301 Parts Manual
![Husqvarna T50 RS 965896301 Lawn Mower manual cover](/images/GpLKGfJKOXfjyZjeijWGRDAx/thumbs/thumb175x175.webp)
To start the Husqvarna T50 RS, first ensure the lawn mower is on a flat surface. Check that the fuel tank is filled and the spark plug is connected. Pull the choke lever to the full position if the engine is cold. Then, pull the starter handle firmly until the engine starts.
The Husqvarna T50 RS requires unleaded gasoline with a minimum octane rating of 87. Avoid using gasoline with more than 10% ethanol content.
It's recommended to change the oil after the first 5 hours of use, and then after every 50 hours of operation or at the beginning of each mowing season.
If the mower doesn't start, check the fuel level, ensure the spark plug is connected, and inspect the air filter for blockages. If these are in order, the problem may be with the carburetor or ignition system. Consult the user manual or a professional technician for further troubleshooting.
Regularly inspect the blade for damage or dullness. Sharpen the blade every 20-25 hours of use, or replace it if it is damaged. Always disconnect the spark plug before performing maintenance to ensure safety.
To prevent clogging, mow only when the grass is dry, and ensure the blade is sharp. Regularly clean the underside of the mower deck and discharge chute to remove grass build-up.
The recommended tire pressure for the Husqvarna T50 RS is typically 15 PSI for the rear tires and 20 PSI for the front tires. Always check the user manual for specific recommendations.
To adjust the cutting height, locate the height adjustment levers on each wheel. Move the levers to the desired position, ensuring all four wheels are set to the same height for an even cut.
Excessive vibration can be caused by a damaged blade, loose components, or debris lodged in the mower deck. Inspect and tighten any loose parts, clear debris, and check the blade for damage. Replace the blade if necessary.
To winterize your mower, remove any remaining fuel from the tank, clean the mower deck, and change the oil. Remove the spark plug and add a few drops of oil into the cylinder, then pull the starter rope a few times to distribute the oil. Store the mower in a dry, sheltered area.