Husqvarna 324L Parts Manual
![Husqvarna 324L Trimmer manual cover](/images/HTWnBYuHSQETDunfKfghEfsh/thumbs/thumb175x175.webp)
To start the Husqvarna 324L Trimmer, ensure the power switch is in the 'On' position, press the primer bulb 6 times, set the choke to the full position, and pull the starter rope until the engine fires. Then, move the choke to the half position and pull the rope again until the engine starts.
The Husqvarna 324L Trimmer requires a fuel mixture of 50:1, which means 2.6 ounces of two-stroke oil mixed with 1 gallon of unleaded gasoline.
The air filter should be checked and cleaned after every 10 hours of operation. If you operate the trimmer in dusty conditions, check it more frequently.
If the trimmer line is not feeding properly, ensure the spool is not empty and is wound correctly. Check for any tangles or obstructions, and ensure the line is the correct diameter as specified by the manufacturer.
To replace the trimmer line, remove the trimmer head cover, take out the spool, and remove any remaining line. Wind new line onto the spool, following the directional arrows, and reassemble the head.
Perform regular maintenance by checking the air filter and spark plug every 10 hours, cleaning the cooling system every 25 hours, and inspecting the fuel system every 50 hours.
If the engine does not start, check the fuel level and quality, inspect the spark plug for fouling or damage, and ensure the air filter is clean. Verify that the choke is set correctly and the primer bulb is functioning.
Excessive vibration may be caused by a damaged cutting attachment or loose parts. Inspect the trimmer head and shaft for damage, and tighten any loose screws or bolts.
Yes, the Husqvarna 324L Trimmer can be used for edging by tilting the trimmer head to a vertical position and walking along the edge of the lawn.
For off-season storage, empty the fuel tank and run the engine until it stops to clear the carburetor. Clean the trimmer thoroughly, inspect for any damage, and store it in a dry, secure place.