Husqvarna 1130 STE 96191000400 Parts Manual
![Husqvarna 1130 STE 96191000400 Lawn Mower manual cover](/images/HDjlylDnSsNWyxWCyIgUErbX/thumbs/thumb175x175.webp)
To start the Husqvarna 1130 STE Lawn Mower, ensure the fuel tank is filled and the oil level is adequate. Engage the choke if the engine is cold, and pull the starter handle firmly. Once the engine starts, gradually push the choke in.
If the mower doesn't start, check the fuel level and ensure fresh fuel is used. Verify that the spark plug is clean and properly connected. Additionally, inspect the air filter for clogs and clean or replace it if necessary.
The oil should be changed after the first 5 hours of operation and then every 25 hours of use or at least once per mowing season. Use SAE 30 oil for optimal performance.
Use unleaded gasoline with a minimum octane rating of 87. Avoid using gasoline with more than 10% ethanol content to prevent engine damage.
To adjust the cutting height, locate the height adjustment lever on each wheel. Move the lever to the desired position to set the cutting height between 1.5 inches and 4 inches. Ensure all wheels are set to the same height for an even cut.
At the end of the mowing season, clean the mower thoroughly, change the oil, and remove any fuel from the tank or add a fuel stabilizer. Also, inspect the spark plug and air filter, replacing them if necessary. Store the mower in a dry, sheltered environment.
To sharpen the mower blades, disconnect the spark plug wire for safety, and remove the blade using a wrench. Use a file or a sharpening tool to sharpen the blade evenly. Reinstall the blade securely before reconnecting the spark plug.
Excessive vibration may be caused by an unbalanced blade or loose parts. Check that the blade is balanced and that all nuts and bolts are tightened. If the problem persists, consult the user manual or contact a professional service.
To improve performance in thick grass, ensure the blades are sharp and mow at a higher cutting height to prevent the engine from bogging down. Mow more frequently to avoid cutting large amounts at once.
The recommended spark plug for the Husqvarna 1130 STE is the Champion RC12YC or an equivalent. Ensure the gap is set to 0.030 inches before installation.