Honda TRX250TE FourTrax Recon ES 2024 Manual
![Honda TRX250TE FourTrax Recon ES 2024 ATV manual cover](/images/JhFaeybWpoJRzdxfyxVmaqrf/thumbs/thumb175x175.webp)
To perform an oil change, warm up the engine, place a drain pan under the engine, remove the drain bolt, and allow the oil to fully drain. Replace the drain bolt and fill with the recommended oil type and amount. Check the owner's manual for specific oil specifications.
The recommended spark plug for the Honda TRX250TE FourTrax Recon ES 2024 is an NGK DPR8EA-9. Ensure it is gapped correctly as per the specifications in the owner's manual.
Check the battery for charge and connections, ensure the fuel valve is on, and inspect the spark plug for fouling or damage. Verify that the kill switch is in the 'run' position and that the transmission is in neutral.
The recommended tire pressure for the Honda TRX250TE FourTrax Recon ES 2024 is typically 3.6 psi (25 kPa) for the front tires and 2.9 psi (20 kPa) for the rear tires. Always refer to the owner's manual for confirmation.
The air filter should be inspected every 100 hours of operation or every 12 months, whichever comes first. Replace the air filter if it is excessively dirty or damaged.
After riding through water or mud, thoroughly clean the ATV, inspect the brakes, and check for any trapped water in the airbox. Lubricate all pivot points and inspect the chain for wear or damage.
To adjust the chain tension, loosen the rear axle nuts, adjust the chain tensioners evenly on both sides, ensuring the correct slack as specified in the owner's manual, and then retighten the axle nuts securely.
Yes, E10 fuel (10% ethanol) can be used in the Honda TRX250TE FourTrax Recon ES 2024. However, avoid using fuels with more than 10% ethanol as it may damage the engine or fuel system components.
For winter storage, clean the ATV thoroughly, stabilize the fuel, change the oil, disconnect the battery, and store it in a dry, cool place. Cover the ATV to protect it from dust and moisture.
If your ATV overheats, stop immediately and allow the engine to cool. Check the coolant level and inspect for any leaks. Ensure the radiator is not obstructed and the fan is functioning properly.