Honda Insight 2005 Owner's Manual
![Honda Insight 2005 manual cover](/images/51daceb964ce037177eec9ee/thumbs/thumb175x175.webp)
To reset the maintenance required light, turn the ignition switch to the ON (II) position. Press the Select/Reset knob until the engine oil life indicator is displayed. Press and hold the knob for about 10 seconds until the indicator begins to blink. Release, then press and hold the knob again for about 5 seconds until the indicator resets.
The 2005 Honda Insight requires 0W-20 synthetic motor oil for optimal performance and efficiency. Always refer to the owner's manual for any specific oil brand recommendations.
To improve fuel efficiency, ensure your tires are properly inflated, perform regular maintenance such as oil changes and air filter replacements, drive at steady speeds, and minimize the use of air conditioning.
A squealing noise during startup can often be attributed to a worn or loose serpentine belt. Inspect the belt for any signs of wear and ensure proper tension. Replace if necessary.
Locate the air filter housing in the engine bay. Unclip or unscrew the housing cover and remove the old air filter. Insert the new air filter and ensure it's seated properly. Replace the housing cover and secure it in place.
The check engine light can be triggered by various issues, such as a loose gas cap, faulty oxygen sensor, or a malfunctioning catalytic converter. A diagnostic scan tool is recommended to read the error codes and identify the specific issue.
To replace the 12V battery, turn off the vehicle and disconnect the negative terminal first, followed by the positive terminal. Remove any securing bracket and lift out the old battery. Place the new battery in the tray, reconnect the terminals, positive first, then secure it with the bracket.
The recommended tire pressure for the 2005 Honda Insight is typically 32 psi for the front tires and 30 psi for the rear tires. Always check the placard located on the driver's side door jamb for specific pressure recommendations.
Access the headlight bulb from the engine bay by removing the protective cover behind the headlight assembly. Disconnect the electrical connector and remove the retaining clip or ring. Replace the old bulb with a new one, reattach the retaining clip, reconnect the electrical connector, and replace the cover.
Common causes of a rough idle include dirty fuel injectors, a clogged air filter, vacuum leaks, or faulty spark plugs. Inspect these components and perform regular maintenance to address the issue.