Honda Grom 125 2019 Operation Guide
![Honda Grom 125 2019 Motorcycle manual cover](/images/DEzhVoucBJuMAyOUAehkojiX/thumbs/thumb175x175.webp)
To change the oil on a Honda Grom 125 2019, warm up the engine for a few minutes, then turn it off. Place an oil pan under the drain plug, remove the plug, and let the oil drain completely. Replace the drain plug and remove the oil filler cap. Pour in the recommended amount of new oil, checking the level with the dipstick. Replace the oil filler cap and start the engine to check for leaks.
The recommended tire pressure for the Honda Grom 125 2019 is 29 psi for the front tire and 29 psi for the rear tire. Always check the tire pressure when the tires are cold.
To adjust the chain tension on a Honda Grom 125 2019, place the motorcycle on a stand and locate the chain adjusters on the rear swingarm. Loosen the axle nut, then adjust the chain adjusters evenly on both sides to achieve the proper slack, usually about 1 inch of movement. Tighten the axle nut and recheck the tension.
Use a high-quality ethylene glycol-based coolant that is specifically formulated for aluminum engines, mixed with distilled water in a 50/50 ratio, for your Honda Grom 125 2019. Always check the owner’s manual for specific recommendations.
The spark plug on a Honda Grom 125 2019 should typically be replaced every 8,000 miles or as specified in the owner's manual. Regularly inspect the spark plug for signs of wear or fouling and replace it if necessary.
If your Honda Grom 125 2019 won't start, check the battery for charge, ensure the fuel valve is on, and inspect the spark plug for fouling. Make sure the kill switch is set to 'run' and the bike is in neutral. If these steps don't work, consult a professional mechanic.
To clean the air filter on a Honda Grom 125 2019, remove the seat to access the airbox. Open the airbox and take out the air filter. If it's a foam filter, wash it with soapy water, rinse it thoroughly, and let it dry. Apply a light coat of air filter oil before reinstalling.
The correct idle speed for the Honda Grom 125 2019 is approximately 1,400 ± 100 rpm. If the idle speed needs adjustment, it can typically be done with the idle adjustment screw located near the throttle body.
To improve the fuel efficiency of your Honda Grom 125 2019, ensure regular maintenance such as oil changes and air filter cleaning. Keep tires properly inflated, avoid rapid acceleration and heavy braking, and minimize idling.
For long-term storage of your Honda Grom 125 2019, clean the motorcycle thoroughly, change the oil, and fill the tank with fresh fuel stabilized with a fuel stabilizer. Disconnect the battery, and store the bike in a cool, dry place with the tires off the ground if possible. Cover the motorcycle to protect it from dust and moisture.