Honda GL1800A Gold Wing F6B 2015 Manual
![Honda GL1800A Gold Wing F6B 2015 Motorcycle manual cover](/images/HKpevqnYSXklaIUJDOuNdwdV/thumbs/thumb175x175.webp)
The recommended oil type for the Honda GL1800A Gold Wing F6B 2015 is SAE 10W-30, JASO T 903 standard MA. The oil capacity is approximately 4.9 quarts with a filter change.
To adjust the suspension settings, locate the suspension adjustment knob under the seat. Turn the knob clockwise to increase preload for a firmer ride and counterclockwise for a softer ride, adjusting according to your preference and load.
If the engine won't start, check the battery connections and ensure the battery is fully charged. Verify the kill switch is in the 'run' position and the bike is in neutral. If the problem persists, inspect the fuel level and the starter relay.
The air filter should be inspected every 12,000 miles and replaced if necessary. Under dusty or severe conditions, more frequent replacement may be required.
The recommended tire pressure is 36 psi for the front tire and 41 psi for the rear tire. Always check tire pressure when the tires are cold.
To access the fuse box, remove the left side cover by unscrewing the bolts securing it. The fuse box is located beneath this cover. Refer to the owner's manual for specific locations of individual fuses.
Regularly check the brake fluid level and top it off with DOT 4 brake fluid if necessary. Inspect brake pads for wear and replace them if the pad thickness is less than 1.5 mm. Check the brake lines for any signs of wear or leaks.
To improve fuel efficiency, ensure regular maintenance such as timely oil changes and air filter replacements. Maintain proper tire pressure, avoid aggressive acceleration, and reduce excess weight.
Common electrical issues include battery drain, blown fuses, and faulty wiring connections. Regularly inspect wiring harnesses for damage and ensure all connections are secure. Replace any blown fuses with the correct amperage.
To reset the trip meter, press and hold the trip button on the instrument panel until the trip reading resets to zero. This can be done for both trip meters A and B.