Harley-Davidson Softail Springer Classic 2006 Owner's Manual
![Harley-Davidson Softail Springer Classic 2006 Motorcycle manual cover](/images/CGvZIQYOnzTySJUoKFdsLjSP/thumbs/thumb175x175.webp)
To change the oil, warm up the engine, place the bike on a stand, and locate the oil drain plug beneath the bike. Use a wrench to remove the plug and allow the oil to drain completely. Replace the drain plug, then remove the oil filter using an oil filter wrench. Install a new oil filter and fill the engine with recommended oil.
The recommended tire pressure for the 2006 Softail Springer Classic is typically 36 psi for the front tire and 40 psi for the rear tire. Always refer to the owner's manual or the tire manufacturer's recommendations for specific details.
If the bike won't start, check the battery charge, fuses, and the starter relay. Ensure the kill switch is set to 'run' and the fuel valve is open. If problems persist, inspect the spark plugs and ignition system for faults.
To adjust the clutch, locate the clutch cable adjuster and loosen the locknut. Turn the adjuster to achieve the desired free play in the clutch lever. Tighten the locknut and ensure the clutch operates smoothly.
The primary chain should be inspected and adjusted every 5,000 miles. To adjust, remove the primary cover, check for the correct tension, and adjust using the tensioner bolt. Replace the cover and ensure proper sealing.
To winterize the bike, clean and wax all surfaces, change the oil and filter, add a fuel stabilizer to the gas tank, and disconnect the battery. Store the bike in a dry, temperature-controlled environment and cover it to prevent dust accumulation.
Inspect fuel lines, connections, and the fuel tank for signs of wear or damage. Tighten any loose connections and replace damaged components. If the leak persists, consult a professional mechanic to inspect the fuel system.
The recommended brake fluid for the 2006 Softail Springer Classic is DOT 4. Ensure to use a high-quality brand and follow proper bleeding procedures to maintain brake efficiency and safety.
Regularly inspect the belt for signs of wear, cracks, or damage. Check the belt tension with a tension gauge; the specifications are typically found in the owner's manual. Adjust the tension by loosening the axle nut and turning the adjuster screws.
Common causes of overheating include low oil levels, clogged air filters, and faulty cooling systems. To prevent overheating, regularly check oil levels, replace air filters as needed, and ensure the cooling system is functioning properly.