Ford Flex 2011 Owners Guide
![Ford Flex 2011 manual cover](/images/SOYofrlGjRJRaCiqLugPbmji/thumbs/thumb175x175.webp)
The 2011 Ford Flex typically requires 5W-20 synthetic blend motor oil. Always consult the owner's manual for the most accurate information.
To reset the oil change light, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within 10 seconds. The light should reset.
The recommended tire pressure for the 2011 Ford Flex is typically 35 PSI for both front and rear tires. Check the placard on the driver’s side door jamb for confirmation.
To replace the headlight bulb, open the hood and locate the back of the headlight assembly. Disconnect the electrical connector, remove the rubber boot, and twist the bulb counterclockwise to remove it. Install the new bulb by reversing these steps.
A rough idle could be caused by several factors including dirty fuel injectors, a clogged air filter, or spark plug issues. It's recommended to perform regular maintenance and diagnostics to identify the exact cause.
Check the transmission fluid level by warming up the engine and parking the vehicle on a level surface. With the engine running, remove the dipstick, wipe it clean, reinsert it, then pull it out again to check the fluid level. It should be within the marked area on the dipstick.
Common issues can include a faulty compressor, refrigerant leaks, or a malfunctioning blower motor. Regular maintenance can help prevent these problems.
The cabin air filter should be replaced every 15,000 to 20,000 miles, or as needed if you notice reduced airflow or a musty odor.
The towing capacity of the 2011 Ford Flex is up to 4,500 pounds when properly equipped with the available Class III Trailer Tow Package.
First, check the window fuse and replace if necessary. If the fuse is intact, inspect the window switch and motor for faults. A professional diagnosis may be needed for further issues.