Ford Five Hundred 2005 Owners Guide
![Ford Five Hundred 2005 manual cover](/images/NDKdEMEdyfqAQsdxQGrTDzjx/thumbs/thumb175x175.webp)
To reset the oil change light, turn the ignition to the ON position without starting the engine. Press the SETUP button until the display reads "Oil Life XXX% Hold Reset = New." Press and hold the RESET button until it reads "Oil Life Set To 100%." Turn off the ignition.
The 2005 Ford Five Hundred uses Mercon V automatic transmission fluid. Always check the owner’s manual or with a Ford dealer for the most accurate information.
First, check the battery and connections for corrosion or loose terminals. Ensure the fuel pump is working by listening for a humming noise when the ignition is turned on. Verify that the starter and ignition switch are functioning. If problems persist, a professional diagnostic may be needed.
The recommended tire pressure for the 2005 Ford Five Hundred is typically 32 psi for both front and rear tires. Always check the placard on the driver's side door jamb or the owner's manual for specific recommendations.
To replace the cabin air filter, open the glove box and remove the limiting stop arm. Push in on the sides of the glove box to release it. Remove the filter cover, slide out the old filter, and replace it with a new one. Reassemble the components in reverse order.
A squeaking noise when braking can be caused by worn brake pads, glazed pads, or rotors. Inspect the brake system and replace pads or resurface rotors if necessary. If the noise persists, consider consulting a mechanic.
The transmission fluid level can be checked via the dipstick located near the back of the engine. Ensure the car is on level ground and the engine is warm. Pull out the dipstick, wipe it clean, reinsert it fully, and then remove it again to check the fluid level.
Overheating can be caused by a low coolant level, a faulty thermostat, a malfunctioning radiator fan, or a blocked radiator. Check these components and ensure the cooling system is functioning properly.
Insert the existing key into the ignition and turn it to the ON position. Cycle the ignition from OFF to RUN eight times within ten seconds, ending in RUN. The door locks will cycle to confirm programming mode. Press any button on the new fob to program it. Turn the ignition off to exit programming mode.
Regular maintenance includes oil changes every 5,000 miles, tire rotations every 7,500 miles, and replacing air filters every 15,000 miles. Inspect brakes, belts, and hoses regularly. Refer to the owner's manual for a detailed maintenance schedule.