Ford Expedition 2007 Owners Guide
![Ford Expedition 2007 manual cover](/images/GnTAeTFXYcVMOkraRmBpewsC/thumbs/thumb175x175.webp)
To reset the oil change light, turn the ignition key to the "on" position without starting the engine. Press the "SETUP" button until you see "OIL LIFE" displayed. Press and hold the "RESET" button until the display reads "OIL LIFE SET TO 100%".
The recommended tire pressure for the 2007 Ford Expedition is typically 35 PSI for both front and rear tires. However, it's best to check the sticker on the driver's side door jamb for the most accurate information.
To change the headlight bulb, open the hood and locate the back of the headlight assembly. Remove the power connector, then twist and remove the bulb holder. Replace the old bulb with a new one, reattach the holder, and reconnect the power.
Engine overheating can be caused by a variety of issues such as a faulty thermostat, low coolant levels, a malfunctioning radiator fan, or a blocked radiator. Check these components and consult a mechanic if necessary.
For a 2007 Ford Expedition, Ford recommends using SAE 5W-20 engine oil. Ensure you use oil that meets Ford specification WSS-M2C930-A.
To improve fuel efficiency, ensure your tires are properly inflated, use the recommended oil, keep your vehicle well-maintained, and avoid excessive idling. Also, drive at steady speeds and reduce unnecessary weight in the vehicle.
If your Expedition won't start, check the battery connections, ensure the battery is charged, and listen for a clicking sound which might indicate a starter issue. If these are fine, it could be an issue with the ignition switch or fuel system.
Regular maintenance is recommended every 5,000 miles or every six months, whichever comes first. This includes oil changes, tire rotations, and inspections of critical systems like brakes and fluid levels.
Common transmission issues may include slipping gears, delayed shifting, or a transmission fluid leak. Regular maintenance and fluid checks can help prevent these problems. Consult a professional if you experience any of these symptoms.
Insert the existing key into the ignition and turn it from 'OFF' to 'RUN' eight times within 10 seconds, ending in 'RUN'. The doors will lock and unlock to confirm programming mode. Press a button on the new fob to program it.