Ford Escape 2008 Owners Guide
![Ford Escape 2008 manual cover](/images/WhtTFQuBezOGUTDlbceTyvjB/thumbs/thumb175x175.webp)
To reset the oil change light on a 2008 Ford Escape, turn the ignition to the 'ON' position without starting the engine. Press the 'SETUP' button until the display reads 'Oil Life.' Press and hold the 'RESET' button until the display reads 'Oil Life Set To 100%.' Release the button.
The recommended tire pressure for a 2008 Ford Escape is typically 32 PSI for both front and rear tires. Always refer to the sticker located on the driver's side door jamb for the most accurate information.
To replace the cabin air filter, open the glove box and remove the contents. Push in on both sides of the glove box to release it from the dashboard. Locate the cabin air filter housing, remove the cover, and pull out the old filter. Insert the new filter and reassemble the glove box.
A squealing noise when starting your 2008 Ford Escape may be caused by a worn or loose serpentine belt. Inspect the belt for signs of wear and check the tension. If necessary, replace the belt or adjust the tensioner.
The 2008 Ford Escape typically requires 5W-20 synthetic blend motor oil. Always check your owner's manual to confirm the correct oil specification for your specific engine.
To troubleshoot the check engine light, use an OBD-II scanner to read the diagnostic trouble codes (DTCs) stored in the vehicle's computer. The codes will help identify the issue. Address the underlying problem based on the codes retrieved.
The towing capacity of a 2008 Ford Escape is approximately 1,500 pounds for the 2.3-liter engine and up to 3,500 pounds for the 3.0-liter V6 engine, when properly equipped with a towing package.
To change a flat tire, locate the spare tire, jack, and lug wrench in the rear cargo area. Loosen the lug nuts slightly, then jack up the vehicle. Remove the lug nuts and flat tire, then mount the spare tire. Tighten the lug nuts and lower the vehicle. Ensure all lug nuts are securely tightened.
If the air conditioning is not blowing cold air, check the refrigerant level, as it may be low. Also, inspect the compressor, condenser, and related components for any signs of damage or leaks. Consider having a professional perform a detailed inspection.
To pair your phone, ensure that the Bluetooth feature is enabled on your phone. In the vehicle, press the 'Phone' button on the audio system, then select 'Add' or 'Pair.' Follow the prompts to enter the provided passkey on your phone to complete the pairing process.