Fiat 500 2012 Owner's Manual
![Fiat 500 2012 Hatchback manual cover](/images/SxFmdCdyxQTPgdSsSWNlhKpf/thumbs/thumb175x175.webp)
To reset the oil change light, turn the ignition to the "ON" position without starting the engine. Press the accelerator pedal three times within 10 seconds. Turn the ignition off and then start the engine to ensure the light has been reset.
The recommended tire pressure for the 2012 Fiat 500 Hatchback is typically 32 psi for both the front and rear tires. However, it's best to check the sticker on the driver's side door jamb for the most accurate information.
To improve fuel efficiency, regularly check and maintain the correct tire pressure, perform regular engine maintenance, avoid carrying excess weight, drive smoothly, and use cruise control on highways when possible.
A squealing noise when braking may indicate worn brake pads or a buildup of dust and debris. It's advisable to have the brake system inspected and serviced by a qualified mechanic to address the issue.
The 2012 Fiat 500 Hatchback typically uses a HOAT (Hybrid Organic Acid Technology) coolant. Always refer to the owner's manual or consult with a Fiat dealership for the correct type and mixture ratio.
To replace the key fob battery, remove the key from the fob, use a small screwdriver to gently pry apart the fob, remove the old battery, and insert a new CR2032 battery with the positive side facing up. Snap the fob back together.
If the check engine light turns on, first check for any loose gas cap as it might trigger the light. If this isn't the issue, have the vehicle's diagnostic system scanned for error codes to identify the problem.
For the 2012 Fiat 500, it is generally recommended to replace the timing belt every 60,000 to 100,000 miles. Consult the owner's manual or a trusted mechanic for the exact recommendation based on driving conditions.
Common causes of overheating include a low coolant level, a faulty thermostat, a blocked radiator, or a malfunctioning water pump. Regular maintenance and inspections can help prevent these issues.
If the electronic trunk release is not working, you can manually open the trunk by accessing the emergency release lever located inside the trunk. Fold down the rear seats, reach into the trunk, and pull the lever to open the trunk.