Bosch Series 6 WGG244ARGB Energy Label

To start a washing cycle, load your laundry, add detergent, and select the desired program using the program selector. Press the 'Start/Pause' button to begin the cycle.
Check if the drain hose is blocked or kinked. Ensure that the pump filter is not clogged. You may also refer to the user manual for detailed troubleshooting steps.
To clean the detergent drawer, pull it out gently until it stops. Press down on the release lever and remove it completely. Rinse under warm water and use a brush to remove any residue before reinserting.
Regularly clean the detergent drawer, run an empty hot wash with vinegar or a washing machine cleaner, and inspect the door seal for debris. Also, ensure the filter is cleaned periodically.
Select the desired program and press the 'Delay Start' button. Use the control dial to set the delay time. Press 'Start/Pause' to activate the delayed start.
Ensure the washing machine is level and all transit bolts have been removed. Make sure the load is balanced and not too heavy on one side.
Press the 'Start/Pause' button to stop the machine. Wait for the door lock indicator to turn off before opening the door to add or remove items.
Leave the door and detergent drawer slightly open after each wash to allow air circulation. Regularly clean the door seal and use a washing machine cleaner monthly.
The 'Eco' mode uses lower washing temperatures and energy-efficient cycles to save energy while maintaining cleaning performance.
To reset the machine, turn the program selector to the 'Off' position, wait a few seconds, and then select a new program. Press 'Start/Pause' to begin the cycle again.