Bosch Series 4 WTN83201GB Energy Label

To clean the lint filter, open the dryer door and pull out the lint filter. Remove any lint by hand or with a soft brush. Rinse the filter under warm water if needed and allow it to dry completely before reinserting.
Check if the power supply is connected properly. Make sure the settings are correct and that the selected program requires heat. If the problem persists, inspect the thermal fuse and heating element, and consult the user manual or a technician.
Use the 'Anti-Crease' option available on the dryer. Remove clothes promptly after the cycle ends and shake them out before folding or hanging.
Regularly clean the lint filter after every use, check the moisture sensor and clean it with a damp cloth, and ensure the exhaust duct is clear of obstructions.
Unusual noises may be due to unbalanced loads, foreign objects in the drum, or worn drum support rollers. Check inside the drum and balance the load. If noise persists, consult a technician.
Select the desired drying program and press the 'Delay Start' button. Use the buttons to set the desired delay time, then press 'Start' to activate the feature.
Check if the power supply is consistent. The dryer might be overheating, so ensure proper ventilation. Inspect the door latch and ensure the door is fully closed.
Dry full loads without overloading, use the moisture sensor drying option, and ensure the lint filter and exhaust ducts are clean for optimal airflow.
Ensure the door is closed properly and check if the power cord is plugged in. Verify that the program and settings are selected. If the issue continues, inspect the door switch and control board.
Yes, use the 'Delicate' or 'Low Heat' setting designed for sensitive fabrics to prevent damage. Always check garment care labels before drying.