Bosch Series 4 DWK87CM60B Energy Label
![Bosch Series 4 DWK87CM60B Hood manual cover](/images/IQuOBvClsYczEayUSiWEYGRj/thumbs/thumb175x175.webp)
To install the Bosch Series 4 DWK87CM60B Hood, refer to the installation guide included with the product. Ensure proper alignment with your kitchen space, secure the hood with appropriate screws, and connect the ductwork and electrical supply as per the manual instructions.
If the hood does not turn on, first check if it is properly plugged in and that the circuit breaker is not tripped. Verify that the power supply is working. If the issue persists, consult the troubleshooting section of the user manual or contact Bosch customer service.
The filters of the Bosch DWK87CM60B Hood should be cleaned every 3-4 weeks, depending on usage. The metal grease filter can be washed in the dishwasher, while the carbon filter (if installed) needs to be replaced every 4-6 months.
To remove stubborn grease, use a soft cloth with a mild detergent or a specific stainless-steel cleaner. Avoid abrasive pads or cleaners that might scratch the surface. Wipe in the direction of the grain for best results.
Yes, the Bosch DWK87CM60B Hood can be used in recirculating mode without an external exhaust. You will need to install an activated carbon filter to remove odors from the air before it is recirculated back into the kitchen.
To change the lighting, ensure the hood is turned off and cool. Access the light compartment as described in the manual, remove the old bulbs, and replace them with new ones of the same type and wattage.
Unusual noises can be caused by loose parts or obstructions in the fan. Turn off the hood and inspect for any visible issues. Tighten any loose screws and ensure the fan is unobstructed. If the problem persists, contact a qualified technician.
To improve suction power, ensure the filters are clean and not blocked. Check that the ductwork is free of obstructions and properly sized. Operating the hood on a higher setting can also increase suction, but ensure it is necessary to avoid excessive noise and energy use.
To reduce noise levels, ensure the hood is securely mounted and that no parts are loose. Operating the hood at a lower speed setting can also reduce noise. Consider using sound-absorbing materials around the installation area if noise remains an issue.
To reset the filter indicator, press and hold the reset button on the hood control panel for approximately 3-5 seconds until the indicator light turns off. Refer to the user manual for exact instructions as button configurations may vary.