Arneg Valencia Installation and Use Manual
![Arneg Valencia Refrigerated Cabinet manual cover](/images/bjtoLhiittPgRvDyGgICIpiq/thumbs/thumb175x175.webp)
To set the temperature, locate the control panel on the cabinet. Use the up and down arrow buttons to adjust the temperature to the desired level. Confirm the setting by pressing the 'Enter' button.
First, check if the cabinet is plugged in and the power supply is stable. Ensure that the door seals are intact and not obstructed. If the problem persists, inspect the condenser coils for dust buildup and clean them if necessary.
It is recommended to clean the condenser coils every three months to maintain optimal performance and efficiency. Use a brush or vacuum to remove dust and debris.
To defrost the cabinet, turn off the unit and remove all contents. Leave the door open to allow the ice to melt naturally. Place towels at the bottom to soak up water. Once defrosted, clean and dry the interior before restarting the unit.
Ensure the door seals are intact to prevent cold air leakage. Keep the cabinet away from heat sources and direct sunlight. Regularly clean condenser coils and avoid overloading the cabinet to allow proper air circulation.
Check the drain line for clogs and clear any obstructions. Ensure that the cabinet is level to allow proper drainage. If the issue persists, inspect the door gaskets for damage or wear.
Unusual noises can be due to a loose component or the cabinet being unlevel. Ensure all parts are securely fastened and the cabinet is on a stable, level surface. If the noise continues, contact a professional technician.
Regular maintenance is key. Clean the interior and condenser coils regularly, ensure proper sealing of doors, and avoid frequent door openings. Schedule professional check-ups annually to maintain performance.
Yes, the lighting can be replaced. Ensure the unit is turned off and unplugged before replacing the bulb. Refer to the user manual for the correct bulb type and installation instructions.
To reset the control panel, turn off the cabinet and unplug it from the power source. Wait for at least 5 minutes before plugging it back in. Turn the unit on and check if the control panel has reset.