Arneg Praga Installation and Use Manual
![Arneg Praga Refrigerated Cabinet manual cover](/images/fvSUxYDQecCyFJERtzBLaOKc/thumbs/thumb175x175.webp)
To clean the Arneg Praga Refrigerated Cabinet, first unplug the unit. Remove all products and shelves. Use a mild detergent with warm water to clean the interior and exterior surfaces. Avoid abrasive cleaners and ensure all surfaces are dry before plugging the unit back in.
Check if the condenser coil is clean and free from dust or debris. Ensure the door is sealing properly and inspect the thermostat settings. If the issue persists, contact a qualified technician for further diagnosis.
The condenser coils should be cleaned every three months to maintain optimal performance. Dust and debris can accumulate, causing the unit to work harder and less efficiently.
Water pooling can be due to a blocked drain line. Check and clear any obstructions in the drain line. Ensure that the cabinet is level, as this can also affect drainage.
Unusual noises can result from a loose component or a malfunctioning fan motor. Inspect for any loose screws or parts. If the noise persists, consult with a technician to examine the fan and compressor.
Yes, the shelves in the Arneg Praga Refrigerated Cabinet are adjustable. You can reposition them to accommodate different product sizes by removing and reinserting them at the desired height.
Ensure that the door seals are intact and replace them if worn out. Regularly clean the condenser coils and avoid overloading the cabinet to allow proper air circulation.
It is not recommended to use extension cords with the refrigerated cabinet. Extension cords can overheat and cause electrical hazards. Plug the unit directly into a wall outlet.
The recommended ambient temperature for optimal operation of the Arneg Praga Refrigerated Cabinet is between 16°C and 32°C (60°F and 90°F). Operating outside this range can affect performance.
After a power outage, wait a few minutes before plugging the unit back in. This prevents electrical surges. Reset the thermostat to the desired setting and monitor the temperature to ensure stability.