Acura TSX 2007 Navigation Manual
![Acura TSX 2007 Sedan manual cover](/images/IKPdtGzVPiiClERPaznIaIxL/thumbs/thumb175x175.webp)
To reset the maintenance light, turn the ignition switch to the ON position. Press the SELECT/RESET knob until the engine oil life indicator appears. Press and hold the SELECT/RESET knob for more than 10 seconds. The indicator will reset to 100%.
Acura recommends using SAE 5W-30 viscosity engine oil for the 2007 TSX. It is also important to use oil that meets the API classification of SL or higher.
First, check the refrigerant level to ensure it is adequate. Inspect the A/C compressor and belts for any signs of wear or damage. Verify that the air conditioning fuse is intact. If the problem persists, it may be necessary to have the system inspected by a professional for possible leaks or compressor issues.
The recommended tire pressure for a 2007 Acura TSX is 32 psi for both the front and rear tires. Always check the pressure when the tires are cold for an accurate reading.
To improve fuel efficiency, keep your tires properly inflated, perform regular maintenance including oil changes and air filter replacements, and avoid aggressive driving. Additionally, removing excess weight from the vehicle and using cruise control on highways can help.
Check the battery for adequate charge and ensure the terminals are clean and tight. Inspect the ignition switch and starter for signs of failure. Verify the fuel level and ensure the fuel pump is functioning. If the issue persists, consult a professional mechanic.
Open the glove box and detach the damper. Remove the glove box stops to allow it to drop completely. Access the cabin air filter cover, remove it, and then replace the old filter with a new one. Reassemble in reverse order.
Common transmission issues can arise from low or contaminated transmission fluid, worn clutch components, or faulty solenoids. Regular maintenance and prompt attention to warning signs can help mitigate these issues.
Insert the key into the ignition and turn it to the ON position. Press the LOCK button on the fob. Turn the key to the OFF position and repeat the process two more times. Turn the key back to ON, press the LOCK button again, and the system should cycle the locks to confirm programming.
Check the coolant level and refill if necessary. Inspect the radiator and hoses for leaks or blockages. Verify that the cooling fans are operational. Ensure that the thermostat is functioning correctly. If the problem persists, consult a professional to check for more serious issues such as a blown head gasket.