Acura TL 2003 Navigation Manual
![Acura TL 2003 Sedan manual cover](/images/mQpUKLhSPgmEiWGUaZQukAkZ/thumbs/thumb175x175.webp)
To reset the maintenance required light, turn the ignition switch to the ON position. Press and hold the Select/Reset button on the instrument panel, then turn the ignition switch to the OFF position. While holding the button, turn the ignition switch back to ON and hold the button until the maintenance light turns off.
The 2003 Acura TL Sedan typically requires 5W-20 motor oil. It is recommended to use synthetic oil for better performance and protection. Always check the owner’s manual for the manufacturer’s recommendations.
First, check the radio fuse in the fuse box to ensure it is not blown. If the fuse is intact, try resetting the radio by disconnecting the car battery for a few minutes. If the issue persists, it might be necessary to consult a professional, as there could be an internal problem with the radio unit.
Common causes of engine overheating include a faulty thermostat, low coolant levels, a leaking radiator, or a malfunctioning water pump. Regularly check coolant levels and inspect the cooling system components for leaks or damage.
To replace the cabin air filter, open the glove box and remove the stops by pressing them inward. Lower the glove box completely and locate the cabin filter cover behind it. Unclip the cover and remove the old filter. Insert the new filter with the airflow direction arrow pointing down, then replace the cover and glove box.
A squealing noise during startup is often caused by a worn or loose serpentine belt. Inspect the belt for signs of wear or damage and replace it if necessary. Also, check the belt tensioner for proper operation and adjust it if needed.
The recommended tire pressure for the 2003 Acura TL Sedan is typically 32 psi for both front and rear tires. It is important to check tire pressure regularly and adjust as necessary to ensure optimal performance and fuel efficiency.
To program a new keyless entry remote, insert the key and turn the ignition to the ON position. Press the LOCK or UNLOCK button on the remote, then turn the ignition to the OFF position. Repeat this process three times. Finally, turn the ignition back to ON and press the LOCK or UNLOCK button again. The locks should cycle to confirm programming.
Poor acceleration in a 2003 Acura TL could be due to a clogged air filter, dirty fuel injectors, a failing fuel pump, or transmission issues. Regular maintenance, including replacing air filters and using fuel injector cleaner, can help prevent these problems.
To change the spark plugs, first disconnect the battery. Remove the engine cover and ignition coil bolts, then carefully remove the coils. Use a spark plug socket to remove the old spark plugs. Install new spark plugs by hand to avoid cross-threading, then tighten with a torque wrench. Replace the ignition coils and engine cover.