Acura MDX 2003 Navigation Manual
![Acura MDX 2003 SUV manual cover](/images/IHDnsOfwbMdoFgUyCVQijSJs/thumbs/thumb175x175.webp)
To reset the maintenance light on your 2003 Acura MDX, turn the ignition to the "ON" position, but do not start the engine. Press the "Select/Reset" button until the oil life is displayed. Hold down the button until the oil life resets to 100%.
The recommended engine oil for a 2003 Acura MDX is 5W-20, which can provide optimal performance and fuel efficiency. Always check your owner's manual for the most accurate information.
To replace the cabin air filter, open the glove box and remove the damper cord. Press the sides of the glove box inward to release it. The cabin air filter is located behind a panel; remove the panel and replace the filter with a new one.
The 2003 Acura MDX has a towing capacity of up to 4,500 pounds. It's important to ensure that your hitch and towing setup comply with this limit.
If the power window is not functioning, check the fuse first. If the fuse is intact, inspect the window switch and motor for any signs of failure. You may need to remove the door panel to access these components.
Common causes of brake noise include worn brake pads, debris caught between the rotor and pad, or a lack of lubrication on the brake components. Inspecting and servicing the brakes can help resolve these issues.
To check the transmission fluid level, ensure the vehicle is on a level surface and the engine is warm. Remove the dipstick, wipe it clean, insert it back, and then remove it again to check the fluid level. Make sure the fluid is within the marked range.
The "Check Engine" light can be triggered by various issues, such as a loose gas cap, a faulty oxygen sensor, or an issue with the catalytic converter. A diagnostic scan can help identify the specific cause.
To jump-start your Acura MDX, connect the positive cable to the positive terminal of the dead battery and the other end to the positive terminal of the donor battery. Connect the negative cable to the negative terminal of the donor battery and the other end to an unpainted metal surface on the engine block of the dead car. Start the donor vehicle, then start your MDX.
The recommended tire pressure for a 2003 Acura MDX is typically 32 psi for both front and rear tires. Always check the tire information placard located on the driver's side door jamb for the most accurate information.