Acura ILX 2019 Navigation Manual
![Acura ILX 2019 Sedan manual cover](/images/nfpiGbRlBUinQuCdPJeymbqx/thumbs/thumb175x175.webp)
To reset the maintenance light on a 2019 Acura ILX, turn on the ignition without starting the engine, use the steering wheel buttons to select the Maintenance option on the display, hold the SEL/RESET button until the reset option appears, and then confirm the reset.
The 2019 Acura ILX is recommended to use 0W-20 synthetic oil for optimal performance and fuel efficiency.
For the 2019 Acura ILX, it is generally recommended to change the transmission fluid every 30,000 miles under severe conditions, or check the owner's manual for specific intervals under normal conditions.
A squealing noise when braking in a 2019 Acura ILX could be due to worn brake pads, dust or debris between the pad and rotor, or the need for brake pad shims. It's advisable to have the brake system inspected by a professional.
The recommended tire pressure for a 2019 Acura ILX is typically 32 psi for both front and rear tires. Always check the placard on the driver’s door jamb for the most accurate information.
To pair your phone with the 2019 Acura ILX Bluetooth system, enable Bluetooth on your phone, select “Phone” on the vehicle’s infotainment system, and follow the prompts to add a new device, ensuring your phone is discoverable.
If the key fob battery is low, replace it with a new CR2032 battery. Open the fob by inserting a flat tool into the seam, remove the old battery, and insert the new one with the positive side facing up.
To increase fuel efficiency, ensure tires are properly inflated, perform regular maintenance like oil changes and air filter replacements, avoid excessive idling, and drive at consistent speeds.
The 2019 Acura ILX is not designed for towing, and it is not recommended to tow trailers with this vehicle to avoid damage and ensure safety.
To replace a headlight bulb, open the hood, disconnect the electrical connector from the bulb, remove the old bulb by turning it counterclockwise, and install the new bulb by aligning and turning it clockwise. Reconnect the electrical connector.