Acura CL 2002 Navigation Manual
![Acura CL 2002 Sedan manual cover](/images/XpWzPKnhRdiRSSrCsZHimhyR/thumbs/thumb175x175.webp)
To reset the maintenance required light, turn the ignition switch to the ON position, but do not start the engine. Press and hold the Select/Reset button on the instrument panel, then turn the ignition switch to the OFF position and back to the ON position while continuing to hold the button. Hold the button until the light turns off.
The recommended oil type for a 2002 Acura CL Sedan is 5W-30 motor oil. Ensure it meets the API certification for optimal performance.
First, check for any obvious issues such as a loose gas cap. If the problem persists, use an OBD-II scanner to read the diagnostic trouble codes (DTCs). Address the codes accordingly or consult a professional mechanic.
The recommended tire pressure for the 2002 Acura CL Sedan is typically 32 psi for both front and rear tires. However, refer to the sticker on the driver's side door jamb for the most accurate information.
Open the glove box and remove the screws or tabs that hold it in place. Lower the glove box to access the cabin air filter compartment. Remove the old filter and replace it with a new one, ensuring the airflow direction matches the arrows on the filter.
Common causes of overheating include a malfunctioning thermostat, a leaking coolant system, a faulty water pump, or a clogged radiator. It's essential to inspect these components if you experience overheating.
To jump-start the Acura CL, connect the positive cable to the positive terminal of the dead battery and the other end to the positive terminal of the booster battery. Connect the negative cable to the negative terminal of the booster battery and the other end to a metal ground on the vehicle. Start the booster vehicle, then start the Acura.
The recommended spark plug type for the 2002 Acura CL Sedan is an NGK Laser Iridium or a Denso Iridium plug. These offer the best performance and longevity for your engine.
Insert the key into the ignition and turn it to the ON position. Press the LOCK or UNLOCK button on the remote. Turn the ignition to the OFF position and repeat this step three more times. Finally, turn the ignition to ON, press the LOCK button on the new remote, and turn the ignition off to complete the programming.
Check the refrigerant level, as low refrigerant can cause the AC to blow warm air. Also, inspect the AC compressor, condenser, and cabin air filter for any signs of malfunction or blockage. Consider having a professional diagnose the system if issues persist.