Whirlpool WFP2715HC Installation Instructions
![Whirlpool WFP2715HC Washer Dryer manual cover](/images/zexKvjOHRLJRrTYRTmDTvbih/thumbs/thumb175x175.webp)
To start a wash cycle, first load your laundry into the drum. Next, add the appropriate amount of detergent. Close the door and select your desired wash cycle using the control panel. Finally, press the 'Start' button to begin the wash cycle.
First, ensure that the appliance is properly plugged into a functioning power outlet. Check if the circuit breaker has tripped or if there is a blown fuse. If the issue persists, consult the user manual for additional troubleshooting steps or contact customer support.
Remove the dispenser drawer by pulling it out until it stops, then press the release lever to fully remove it. Rinse the drawer under warm running water to remove any detergent residue. Use a soft brush for stubborn deposits, then dry and reinsert the drawer.
Regular maintenance includes cleaning the detergent drawer, inspecting and cleaning the door seal, checking and cleaning the lint filter, and ensuring the water inlet hoses are free from blockages. Additionally, run a monthly maintenance wash using a washing machine cleaner.
Ensure the appliance is level by adjusting the feet. Check if the load is balanced and redistribute the laundry if necessary. Avoid overloading the machine and make sure it is installed on a solid, stable surface.
Check if the lint filter is clean, as a clogged filter can reduce drying efficiency. Ensure the exhaust vent is not blocked. Verify that the selected drying cycle is appropriate for the load size and fabric type.
Refer to the user manual to identify the error code and follow the recommended troubleshooting steps. If the problem persists, contact Whirlpool customer service for further assistance.
Leave the door open after each wash to allow the interior to dry. Regularly clean the door seal and run a maintenance wash with a washing machine cleaner monthly to keep mold and mildew at bay.
To reset the washer dryer, unplug the appliance from the power outlet for about five minutes. Plug it back in and turn it on. This may clear minor issues and reset the control board.
Run an empty wash cycle using hot water and two cups of white vinegar to clean and deodorize the drum. Ensure to clean the detergent drawer and door seal as well. Regular maintenance washes will help prevent odors.