Vax W91-RS-B-A, W91-RS-B Carpet Instruction Manual

To assemble the Vax W91-RS-B-A, start by attaching the handle to the main body of the vacuum. Ensure it clicks into place. Next, attach the hose to the inlet and secure it with the clips provided. Refer to the user manual for detailed instructions and diagrams.
If your Vax vacuum loses suction, check for blockages in the hose, filters, and brushes. Ensure the dust container is not full and the filters are clean. Clean or replace the filters as necessary and clear any blockages.
Filters should be checked and cleaned after every three uses. Rinse the filters under lukewarm water until the water runs clear. Allow them to air dry completely before reinserting them into the vacuum.
Use only Vax-approved carpet cleaning solutions with the Vax W91-RS-B-A model. These solutions are specially formulated to work effectively with your machine and avoid damage.
If the brush bar is not rotating, check that the vacuum is not set to 'hard floor' mode. Inspect the brush bar for obstructions and remove any debris. Check if the belt connecting the motor to the brush is intact and replace it if necessary.
To clean upholstery, attach the upholstery tool to the hose. Fill the water tank with a mix of water and Vax carpet cleaning solution. Use the tool to spray and scrub the fabric, then extract the dirty water back into the vacuum.
Store the Vax W90-RS-B in a dry, indoor location. Ensure the power cord is neatly wound and secured. Keep the vacuum upright to prevent damage to the components.
To replace the belt, turn off and unplug the vacuum. Remove the screws securing the brush cover and lift it off. Slide the brush bar out and remove the old belt. Fit the new belt around the motor shaft and brush bar, then reassemble the vacuum.
If your Vax W91-RS-B-A leaks water, ensure the water tank is properly fitted and not overfilled. Check all seals and gaskets for damage and replace if necessary. Make sure hoses are securely connected.
Regularly check the power cord for signs of wear or damage. Avoid winding the cord too tightly to prevent kinks. Store the vacuum with the cord loosely wound to extend its lifespan.