Vax C88-CX-H, C90-EL, C90-PM, C90-AS, C90-CX2 User's Guide

To clean the filters, first switch off and unplug the vacuum. Remove the dust container and take out the filter. Wash it under running water and allow it to air dry completely before reinserting it into the vacuum.
Check for blockages in the hose, dust container, and filters. Clean or replace the filters if necessary and ensure the dust container is not full.
It is recommended to replace the filters every 3 to 6 months depending on usage frequency to maintain optimal performance.
Yes, the Vax C90-CX2 is suitable for use on hardwood floors. Ensure the brush bar is set to the appropriate setting for hard floors to avoid damage.
Turn off and unplug the vacuum immediately. Check for blockages and clean the filters. Allow the vacuum to cool down for at least 30 minutes before using it again.
Ensure the power cord is plugged in and the power outlet is functioning. Check the fuse in the plug and replace it if necessary.
Store the vacuum in a cool, dry place. Ensure the dust container is empty and the cord is neatly wound to prevent damage.
The loud noise may be due to a blockage or a dirty filter. Check for debris in the hose and clean the filters. If the noise persists, contact customer support.
Periodically remove the brush bar and clean off any hair or debris. Check for any obstructions and ensure it rotates freely.
The Vax C90-PM comes with a crevice tool, a dusting brush, and an upholstery tool. Use the crevice tool for tight spaces, the dusting brush for delicate surfaces, and the upholstery tool for furniture.