Toyota Tacoma 2016 Owner's Navigation Manual

To reset the maintenance required light, turn the key to the "On" position without starting the engine. Press and hold the trip meter reset button, then turn the key to the "Off" position. Continue holding the button, turn the key back to "On," and keep holding until the light goes off.
The recommended tire pressure for a 2016 Toyota Tacoma is typically 30-35 PSI for both front and rear tires. Always check the placard on the driver's side door jamb for specific details.
To pair your phone, enable Bluetooth on your device. On the Tacoma’s Entune system, go to Setup > Bluetooth > Add. Select your Tacoma on your phone, confirm the passkey, and complete pairing.
The towing capacity of a 2016 Toyota Tacoma varies depending on the configuration but can go up to 6,800 pounds when properly equipped. Check the owner's manual for specific details based on your model.
To improve fuel efficiency, ensure regular maintenance, keep tires properly inflated, drive at moderate speeds, avoid excessive idling, and remove unnecessary weight from the truck.
A grinding noise when braking often indicates worn brake pads. It's important to inspect and replace them as needed to avoid damage to the rotors. Seek professional service if unsure.
To change the oil, warm up the engine, turn it off, and drain the old oil by removing the drain plug. Replace the oil filter, then add new oil. Make sure to dispose of the old oil properly.
If the check engine light comes on, check for any obvious issues such as a loose gas cap. If the light persists, use an OBD-II scanner to read the trouble codes or seek professional diagnostics.
It is recommended to check the air filter every 15,000 to 30,000 miles, depending on driving conditions. Replace it if it appears dirty or clogged. Consult the owner’s manual for specific guidance.
A 2016 Toyota Tacoma typically requires SAE 0W-20 synthetic oil. Always refer to the owner's manual for the correct oil specification for your specific model.