Subaru Impreza Base 5-Door Eyesight 2022 Manual

To pair your phone, turn on the Bluetooth on your device. Navigate to the 'Phone' menu on the Subaru's infotainment screen and select 'Add Device'. Follow the prompts on both your phone and the infotainment screen to complete the pairing process.
The recommended tire pressure for the Subaru Impreza Base 5-Door Eyesight 2022 is typically 33 PSI for both front and rear tires. Always refer to the placard located on the driver's side door jamb for specific recommendations.
To reset the maintenance reminder, go to the settings menu on the infotainment screen, select 'Maintenance', choose the service you want to reset, and then select 'Reset'. Confirm your selection to complete the process.
The Subaru Impreza Base 5-Door Eyesight 2022 typically requires synthetic 0W-20 oil. Consult your owner's manual for the most accurate and detailed information.
To enable the Eyesight adaptive cruise control, press the 'Cruise' button on the steering wheel. Once activated, use the 'Set' button to set your desired speed. Adjust the following distance using the distance setting buttons.
To change a flat tire, park the vehicle on a level surface, apply the parking brake, and use the jack to lift the car. Remove the hubcap and loosen the lug nuts, then replace the flat tire with the spare. Tighten the lug nuts and lower the vehicle.
To check the engine coolant level, ensure the engine is cool. Open the hood, locate the coolant reservoir, and verify the fluid is between the 'Full' and 'Low' marks. Add coolant if necessary, using the recommended type.
To update the navigation system, connect the infotainment system to a Wi-Fi network, go to the settings menu, and select 'Map Update'. Follow the on-screen instructions to download and install updates.
If the Eyesight system warning light comes on, ensure the windshield is clean and unobstructed. Restart the vehicle to see if the light resets. If the light persists, consult a Subaru dealer for a diagnostic check.
To replace the cabin air filter, open the glove box and remove the limiting stop arm. Squeeze the sides of the glove box to drop it down, then locate and remove the filter cover. Replace the old filter with a new one and reassemble.