Simplicity 2691678-00 Prestige Parts Manual
![Simplicity 2691678-00 Prestige Tractor manual cover](/images/DWcaLpygMcFhvNslkBTePpRN/thumbs/thumb175x175.webp)
To start the tractor, ensure the parking brake is engaged, the PTO is turned off, and the transmission is in neutral. Insert the key into the ignition and turn it to the "Start" position while ensuring the choke is applied if the engine is cold. Release the key once the engine starts.
If the PTO does not engage, check the PTO switch for faults, ensure the battery is fully charged, and inspect the wiring connections for any signs of damage. If the problem persists, consult the owner's manual for further troubleshooting or contact a professional technician.
Change the engine oil every 50 hours of operation or at the start of each season, whichever comes first. Always use the recommended oil type as specified in the owner's manual.
The recommended tire pressure for the front tires is 14 PSI and for the rear tires is 10 PSI. Ensure to check the tire pressure regularly to maintain optimal performance and avoid uneven wear.
To troubleshoot uneven cutting, check if the mower deck is level, inspect the blades for sharpness and damage, and ensure the tire pressure is correct. Additionally, examine the deck hangers and linkages for wear or damage.
If the tractor won't start, check the battery for a full charge, ensure the spark plugs are in good condition, and verify the fuel level. Additionally, examine the safety switches and fuses for any issues.
To store the tractor, clean it thoroughly, change the oil, and add a fuel stabilizer to the gas tank. Disconnect the battery and store it in a cool, dry place. Cover the tractor to protect it from dust and moisture.
To adjust the mower deck height, locate the lift lever on the right side of the operator's seat. Move the lever to the desired cutting height position, which ranges from 1.5 to 4.0 inches, depending on your preference.
To change the air filter, first, remove the air filter cover by unscrewing the retaining bolts. Take out the old filter and replace it with a new one, ensuring it is seated properly. Reattach the cover securely.
Excessive vibration can be caused by unbalanced or damaged blades, worn engine mounts, or loose hardware. Inspect the blades for balance and damage, check the engine mounts for wear, and tighten any loose bolts or screws.