Simplicity 2691480-00 Prestige Parts Manual
![Simplicity 2691480-00 Prestige Tractor manual cover](/images/hBSlTOdEEiSCTyPNmOUDXZwn/thumbs/thumb175x175.webp)
To change the oil, first warm up the engine, then turn it off and disconnect the spark plug. Place a pan under the oil drain valve, open the valve, and let the oil drain completely. Replace the oil filter, close the drain valve, and refill with the recommended oil type and quantity.
Use fresh, clean, unleaded gasoline with an octane rating of at least 87. Avoid using gasoline with more than 10% ethanol content.
Check the battery connections for tightness and corrosion, ensure there's adequate fuel, and inspect the spark plug for wear. Also, make sure the PTO is disengaged and the parking brake is set.
Regular maintenance includes changing the oil and oil filter, checking and replacing the air filter, sharpening the blades, inspecting belts and hoses, and lubricating the moving parts as per the owner's manual schedule.
Adjust the cutting height by locating the height adjustment lever on the tractor. Move the lever to the desired position, ensuring both sides are set to the same height for an even cut.
Check the transmission fluid level and quality. If it's low or contaminated, refill or replace it. Inspect the drive belt for wear and adjust or replace it if necessary.
Ensure the blades are sharp and balanced, clean the underside of the deck from grass clippings, and check the belt tension. Regularly lubricate the spindles and other moving parts.
Clean the tractor thoroughly, change the oil, stabilize the fuel, remove the battery and store it in a cool, dry place, and cover the tractor to protect it from dust and moisture.
First, disconnect the spark plug and engage the parking brake. Remove the mower deck and locate the drive belt. Follow the routing diagram to remove the old belt and install the new one, ensuring it is properly seated on all pulleys.
Excessive vibration can be caused by unbalanced or damaged blades, loose parts, or worn belts. Inspect and balance the blades, tighten any loose components, and replace worn belts as needed.