Simplicity 2691455-00 Regent Parts Manual
![Simplicity 2691455-00 Regent Tractor manual cover](/images/WhjrrTGNSxdhDuyvZJMuWHbc/thumbs/thumb175x175.webp)
To change the oil, first run the engine for a few minutes to warm up the oil. Turn off the engine and disconnect the spark plug. Place a container under the oil drain valve, open the valve, and let the oil drain completely. Replace the oil filter, close the drain valve, and refill with new oil according to the specifications in the manual.
Check the fuel level and ensure the fuel valve is open. Verify that the battery is charged and the connections are clean and tight. Inspect the spark plug for wear or damage and replace it if necessary. If the problem persists, consult the service manual or a professional technician.
To store the tractor, clean it thoroughly and perform all recommended maintenance. Drain the fuel or add a stabilizer, and run the engine to circulate the treated fuel. Disconnect the battery and store it in a cool, dry place. Cover the tractor to protect it from dust and moisture.
Regular maintenance includes checking and changing the oil, inspecting the air filter, sharpening or replacing the blades, checking tire pressure, and examining belts and hoses for wear. Refer to the owner's manual for a detailed maintenance schedule.
Check the tire pressure to ensure it is even on all sides. Inspect the blades to make sure they are sharp and not bent. Adjust the deck level according to the manual's instructions. If the problem persists, consult a professional for further diagnosis.
Check the transmission fluid level and top it up if necessary. Inspect the belts for signs of wear or damage and replace them if needed. Ensure that all linkage and controls are properly adjusted and functioning. If these steps do not resolve the issue, seek professional assistance.
First, disengage the mower deck and turn off the engine. Remove the old belt by following the routing diagram provided in the manual. Install the new belt, ensuring it is seated properly in all pulleys and follows the correct path. Engage the deck and test the operation.
Excessive vibration can be caused by unbalanced blades, loose parts, or worn bearings. Check that the blades are properly balanced and securely attached. Inspect all bolts and fasteners to ensure they are tight. If these do not resolve the issue, seek professional maintenance.
Refer to the owner's manual for the specific recommended tire pressure for your model. Generally, it should be around 10-14 PSI for rear tires and 12-16 PSI for front tires, but always verify with the manual.
To clean the air filter, remove the cover and take out the filter. If it's a paper filter, tap it gently to remove debris, or replace it if it's too dirty. For foam filters, wash it with warm soapy water, rinse thoroughly, and allow it to dry before reinstallation.