Simplicity 2691337-02 Broadmoor Parts Manual
![Simplicity 2691337-02 Broadmoor Tractor manual cover](/images/HvQlpJmNTnlMoumEWmWLQAyh/thumbs/thumb175x175.webp)
To change the oil, first run the engine for a few minutes to warm it up. Then, turn off the tractor and remove the key. Place an oil pan under the engine, remove the oil drain plug, and let the old oil drain completely. Replace the drain plug and refill with the recommended oil type and amount.
If your tractor won't start, check the battery connections for corrosion and ensure they're tight. Verify that the fuel valve is open and there's sufficient fuel. Check the spark plug for wear or damage and replace if necessary.
Sharpen the mower blades at least once per mowing season or after 25 hours of use, whichever comes first. If you notice uneven cutting or ragged grass tips, the blades may need sharpening sooner.
The recommended tire pressure for the Simplicity 2691337-02 Broadmoor Tractor is typically between 10-14 PSI for front tires and 8-10 PSI for rear tires. Always refer to the owner’s manual for exact specifications.
To level the mower deck, park the tractor on a flat surface. Measure the distance from the ground to the blade tips on both sides. Adjust the deck height using the adjustment nuts on the deck lift linkages until both sides are even.
Excessive vibration can be caused by unbalanced blades, loose parts, or damaged components. Check for debris on the blades, ensure all bolts are tight, and inspect the belts and pulleys for damage.
Remove the air filter cover and take out the filter. If it's a paper filter, tap it gently to remove dirt, or replace it if it's heavily soiled. If it's a foam filter, wash it with mild soap and water, then let it dry completely before reinstalling.
To adjust the throttle cable, locate the throttle control bracket and loosen the adjustment screw. Move the throttle lever to the "Fast" position, then adjust the cable so the throttle control lever on the engine is fully open. Tighten the adjustment screw.
Before storing, clean the tractor thoroughly and change the oil. Add fuel stabilizer to the gas tank, run the engine for a few minutes, and then shut it off. Remove the battery and store it in a cool, dry place. Cover the tractor to protect it from dust and moisture.
To replace the drive belt, first disconnect the spark plug wire. Remove the deck and locate the belt routing diagram. Remove any guards or covers, then slide the belt off the pulleys. Install the new belt following the routing diagram, replace covers, and reconnect the spark plug wire.