Simplicity 2691337-00 Broadmoor Parts Manual
![Simplicity 2691337-00 Broadmoor Tractor manual cover](/images/BxtsLpAPwKYxDvvxzSzJlrMX/thumbs/thumb175x175.webp)
To change the oil, first run the engine for a few minutes to warm it up. Turn off the engine and remove the key. Place an oil pan under the tractor and remove the drain plug. Allow the old oil to drain completely. Replace the drain plug and remove the oil filter. Install a new oil filter and fill the engine with new oil according to the specifications in the manual.
Refer to the Simplicity 2691337-00 Broadmoor Tractor manual for the recommended oil type. Generally, a high-quality SAE 30 oil or a 10W-30 oil is suitable for most operating conditions.
Check the battery to ensure it is fully charged and the terminals are clean and tight. Inspect the spark plugs for wear or damage and replace them if necessary. Ensure the fuel tank has fresh gasoline and the fuel filter is clean. If the problem persists, consult the manual or contact a service technician.
The recommended tire pressure for the Simplicity 2691337-00 Broadmoor Tractor is typically found on the tire sidewall or in the owner's manual. Generally, it ranges between 10-14 PSI for the front tires and 8-10 PSI for the rear tires.
Locate the cutting height adjustment lever, which is typically on the right side of the operator's seat. Move the lever to the desired position, which is indicated by numbers or a scale on the deck. Ensure both sides are adjusted equally for an even cut.
Check for any debris or grass build-up underneath the deck. Inspect the blades for damage or imbalance, and sharpen or replace them if necessary. Ensure all bolts and fasteners are tight, and check the condition of the deck belt for wear or damage.
Regular maintenance should be performed according to the schedule in the owner's manual. Typically, this includes checking the oil level before each use, changing the oil every 50 hours, and inspecting the air filter and spark plugs every season.
To winterize your tractor, remove any remaining fuel from the tank, or add a fuel stabilizer. Clean the mower deck, change the oil, and replace the air filter if necessary. Store the tractor in a dry, covered area and disconnect the battery.
First, ensure the tractor is on a flat surface and the engine is off. Remove the mower deck according to the manual instructions. Release the belt tension and remove the old belt. Install the new belt by following the belt routing diagram, and ensure it is properly seated on all pulleys. Reattach the mower deck.
Always read the operator's manual before use. Wear appropriate safety gear, including hearing protection and sturdy footwear. Ensure the area is clear of people and obstacles. Never operate the tractor on steep slopes, and always disengage the blades and turn off the engine before dismounting.