Simplicity 2691336-00 Broadmoor Parts Manual

To change the oil, first run the engine for a few minutes to warm it up. Then, stop the engine and disconnect the spark plug wire. Place an oil drain pan under the engine's oil drain valve, open the valve, and allow the old oil to drain completely. Replace the oil filter and close the drain valve. Refill with the recommended oil type and capacity. Finally, reconnect the spark plug wire.

If the tractor won't start, check the battery connections to ensure they are clean and tight. Verify that there is fuel in the tank and that the fuel shut-off valve is open. Inspect the spark plug for wear or damage and replace if necessary. Ensure the PTO (Power Take-Off) is disengaged and the brake is fully applied. If the problem persists, consult the user manual or contact a service professional.

To prepare the tractor for winter storage, clean the exterior and undercarriage thoroughly. Add a fuel stabilizer to the fuel tank and run the engine for a few minutes to circulate the stabilizer through the system. Change the engine oil and oil filter. Remove the battery and store it in a cool, dry place. Inflate the tires to the recommended pressure and cover the tractor to protect it from dust and moisture.

Perform regular maintenance every 25 hours of operation or annually, whichever comes first. This includes checking and changing the engine oil, inspecting and cleaning the air filter, checking the spark plug, and lubricating all moving parts. Additionally, inspect belts, blades, and tires periodically and replace them as necessary. Refer to the owner's manual for a detailed maintenance schedule.

To adjust the cutting height, locate the cutting height adjustment lever on the tractor. Move the lever to the desired position to raise or lower the cutting deck. Ensure the deck is level by measuring from the ground to the blade tip on each side and adjust the deck leveling if necessary.

Excessive vibration may be caused by an unbalanced or damaged blade, loose hardware, or debris lodged in the mower deck. Check the blades for damage and balance, tighten any loose bolts or screws, and clear any debris from the deck. If the problem continues, consult a professional technician.

First, disconnect the spark plug wire to prevent accidental starting. Raise the mower deck to its highest position and secure the tractor on a flat surface. Use a wrench to remove the blade bolts and carefully take off the old blades. Install new blades, ensuring they are oriented correctly, and tighten the bolts securely.

If the deck does not engage, check the PTO switch and ensure it is in the "on" position. Inspect the drive belt for signs of wear or damage and replace if necessary. Verify that the engagement cable is connected and functioning properly. If these steps do not resolve the issue, further diagnostic work may be needed by a qualified service technician.

To improve traction on slopes, ensure the tires are properly inflated according to the manufacturer's recommendations. Use wheel weights or tire chains if additional traction is needed. Avoid sudden starts and stops, and always mow up and down the slope, not across it.

The Simplicity 2691336-00 Broadmoor Tractor is designed to operate on unleaded gasoline with an octane rating of 87 or higher. Avoid using gasoline with more than 10% ethanol to prevent engine damage. Always use fresh fuel and store it in a clean, moisture-free container.