Simplicity 2691172-01 Regent EX Parts Manual
![Simplicity 2691172-01 Regent EX Tractor manual cover](/images/CoCaPXnvxeeaKERlIjVJJiPl/thumbs/thumb175x175.webp)
To change the oil, first run the engine for a few minutes to warm it up. Turn off the engine and remove the ignition key. Place a pan under the oil drain valve, open the valve, and let the oil drain completely. Replace the oil filter if needed, close the drain valve, and refill with new oil according to the specifications in the manual.
Use unleaded gasoline with an octane rating of at least 87. Avoid using gasoline with more than 10% ethanol content to prevent engine damage.
Check if the battery is charged and connections are tight. Ensure the PTO switch is in the "off" position and the parking brake is engaged. Verify that there is enough fuel and the fuel valve is open. If the issue persists, consult the manual for further troubleshooting steps.
The recommended tire pressure for the front tires is 14 psi and for the rear tires is 10 psi. Always check the tire pressure when the tires are cold and adjust accordingly.
Raise the deck to the highest position, turn off the engine, and remove the key. Use a garden hose with a spray nozzle to remove grass clippings from the underside of the deck. For stubborn debris, a plastic scraper can be used. Always wear gloves and safety glasses when cleaning the deck.
The air filter should be checked every 25 hours of operation and replaced if it appears dirty or damaged. Under dusty conditions, more frequent checks and replacements may be necessary.
Ensure the blades are sharp and not damaged. Check the blade belt for proper tension and condition. Make sure the deck is level and the cutting height is set correctly. If needed, consult the manual for blade sharpening and replacement procedures.
To winterize your tractor, clean the exterior and cutting deck thoroughly. Change the engine oil and replace the oil filter. Add a fuel stabilizer to the fuel tank and run the engine for a few minutes. Remove the battery and store it in a cool, dry place. Cover the tractor to protect it from dust and moisture.
Before each use, check the oil level, fuel level, and tire pressure. Inspect the cutting deck for debris and ensure the blades are secure. Test the brakes and steering for proper operation. Ensure all safety features are functioning correctly.
To adjust the mower deck height, locate the height adjustment lever on the tractor. Move the lever to the desired cutting height position. Ensure both sides of the deck are at the same height to maintain an even cut.