Simplicity 2691171-00 Regent Parts Manual
![Simplicity 2691171-00 Regent Tractor manual cover](/images/RhGwoUleTJIHPgnBHaVunFVJ/thumbs/thumb175x175.webp)
To change the oil, first warm up the engine to ensure the oil flows smoothly. Turn off the engine and disconnect the spark plug wire for safety. Place an oil pan under the oil drain valve, open the valve, and let the oil drain completely. Replace the oil filter, close the valve, and refill with the recommended oil type and quantity.
For optimal performance, use SAE 10W-30 oil that meets the API service classification SG, SH, SJ, or higher. Refer to the owner's manual for specifics based on operating temperature ranges.
The air filter should be checked before each use and replaced if it appears dirty or is damaged. As a general guideline, replace the air filter after every 100 hours of operation or annually, whichever comes first.
If your tractor won't start, check the battery connections and ensure they are tight and clean. Verify that there is enough fuel and that the fuel valve is open. Inspect the spark plug for damage or wear and replace if necessary. Ensure the PTO switch is disengaged and the brake pedal is fully depressed.
To improve cutting performance, ensure the mower blades are sharp and properly balanced. Check tire pressure to ensure even cutting. Adjust the cutting height as needed for the type of grass and conditions. Regularly clean the underside of the deck to prevent grass build-up.
Excessive vibration can be caused by unbalanced or damaged blades. Inspect the blades for damage and balance them if necessary. Check the mower deck for any obstructions or debris. Ensure all mounting bolts and fasteners are tight.
The recommended tire pressure for the front tires is 14 psi, and for the rear tires, it is 10 psi. Always refer to the tire sidewall or the operator's manual for the most accurate specifications.
To adjust the mower deck, park the tractor on a flat surface and ensure the tires are properly inflated. Lower the deck to the desired height and check side-to-side alignment using a level. Adjust the deck lift links to ensure the deck is level. Check front-to-back pitch and adjust as needed for optimal cutting performance.
Before storing, clean the tractor thoroughly to remove grass and debris. Change the oil and oil filter, and add fuel stabilizer to the fuel tank. Disconnect and store the battery in a cool, dry place. Inflate the tires to the recommended pressure and store the tractor in a dry, protected area.
If the PTO won't engage, check the PTO switch for damage or malfunction. Ensure the battery is fully charged and the electrical connections are clean and secure. Inspect the PTO clutch and ensure it is receiving power. If the problem persists, consult a professional technician.