Simplicity 2691102-00 Regent Parts Manual
![Simplicity 2691102-00 Regent Tractor manual cover](/images/rcuLIqlvmurzgMlQEtnTZXnC/thumbs/thumb175x175.webp)
To perform regular maintenance, ensure you check the oil level and replace the oil filter every 50 hours of operation. Additionally, inspect the air filter, clean the mower deck, and check the tire pressure regularly.
It is recommended to use SAE 30 oil for temperatures above 32°F and SAE 10W-30 or 5W-30 for temperatures below 32°F to ensure proper lubrication.
First, check the battery connections and ensure they are clean and tight. Verify the fuel level and quality, and inspect the spark plug for wear or damage. If the problem persists, consult the manual for further troubleshooting steps.
To replace the mower deck belt, first disengage the PTO and set the parking brake. Remove the mower deck, then take off the old belt and install the new one, ensuring it is properly aligned with the pulleys before reattaching the deck.
Ensure the mower deck is level by adjusting the deck hangers. Check the blades for sharpness and damage, and replace if necessary. Uneven tire pressure can also cause uneven cuts, so verify tire inflation as well.
Blades should be sharpened after every 25 hours of use or at the start of each mowing season. Dull blades can tear grass rather than cut it cleanly, leading to a ragged lawn appearance.
To winterize your tractor, clean the mower deck and remove any debris. Drain the fuel system or add a fuel stabilizer, change the oil and oil filter, and store the tractor in a dry, covered location. Disconnect the battery and store it in a cool, dry place.
To adjust the cutting height, use the height adjustment lever located on the right side of the tractor. Move the lever to the desired position, which is indicated by the corresponding height markings.
Excessive vibration can be caused by unbalanced blades or debris lodged in the mower deck. Check the blades for balance and ensure they are securely attached. Also, inspect the deck for any obstructions and remove them.
To clean the air filter, remove the filter cover and take out the filter. If it is a paper filter, tap it gently to remove dirt. For foam filters, wash with soap and water, rinse, and allow it to dry before reinstalling.