Simplicity 2690659 Legacy XL Parts Manual

The recommended oil type for the Simplicity 2690659 Legacy XL Tractor is SAE 10W-30, meeting API service classification SG or higher. The engine oil capacity is approximately 1.6 quarts (1.5 liters) with an oil filter change.

First, check the PTO switch and wiring for any signs of damage or loose connections. Ensure the battery is fully charged as the PTO requires proper voltage. Inspect the PTO clutch for wear and adjust the air gap if necessary. Consult the manual for specific adjustment procedures.

To change the mower deck belt, first, disengage the PTO and turn off the tractor. Lower the mower deck to its lowest position, remove the belt covers, and then carefully remove the old belt from the pulleys. Install the new belt by following the routing diagram in the manual, ensuring proper tension and alignment.

General maintenance should be performed at regular intervals, including checking the oil level before each use, changing the oil every 50 hours of operation, and replacing the air filter every 100 hours or annually. Additionally, inspect belts, blades, and tires regularly for wear or damage.

If the tractor won't start, check the battery connections and ensure they are clean and tight. Verify the fuel level and that the fuel valve is open. Inspect the spark plug for fouling or damage and replace if necessary. Ensure the throttle and choke are set correctly before starting.

Adjust the cutting height by using the height adjustment lever, which is typically located on the right side of the operator’s seat. Move the lever to the desired cutting height position, ensuring the deck is level for an even cut.

To winterize the tractor, clean the exterior and undercarriage to remove debris. Drain the fuel system or add a fuel stabilizer to prevent gumming. Change the engine oil and filter, lubricate all pivot points, and remove the battery for storage in a cool, dry place. Cover the tractor to protect it from dust and moisture.

Check the tire pressure using a reliable pressure gauge and inflate the tires to the recommended PSI, which can be found in the operator's manual. Ensure all tires are inflated equally for optimal performance and stability.

Remove the air filter cover and take out the filter. If it’s a foam filter, wash it with warm soapy water, rinse thoroughly, and allow it to dry completely before reinstalling. If it’s a paper filter, gently tap it to remove dirt or replace it if excessively dirty.

Overheating can be caused by debris blocking the air intake or clogged cooling fins. Clean these areas thoroughly to ensure proper airflow. Check the coolant level if applicable, and ensure the radiator is clean and free of obstructions. Replace any damaged cooling components.