Simplicity 2690226 Legacy XL Parts Manual
![Simplicity 2690226 Legacy XL Tractor manual cover](/images/utjGvLOWTEXUHZiCBThiNISU/thumbs/thumb175x175.webp)
To change the oil, first warm up the engine. Turn off the engine and remove the oil drain plug, allowing the oil to completely drain into a pan. Replace the drain plug and remove the oil filter. Install a new filter and fill the engine with the recommended oil type and quantity. Check for leaks and proper oil level.
If your tractor won't start, check the battery connections for corrosion or looseness. Ensure that the battery is charged. Verify that the fuel is fresh and the fuel filter is not clogged. Check the spark plugs for wear or fouling and replace if necessary.
Uneven cutting may be due to improperly inflated tires, a bent blade, or a misaligned deck. Check tire pressure first, then inspect the blades for damage. Finally, adjust the deck level according to the manual instructions.
Regular maintenance includes checking the oil level before each use, replacing the oil and oil filter every 50 hours, inspecting the air filter every 25 hours, and sharpening or replacing blades as needed. Lubricate all moving parts and check the tire pressure regularly.
To adjust the mower deck height, locate the deck lift lever on the tractor. Move the lever to the desired cutting position, ensuring that the deck is level from side to side. Refer to your manual for specific height settings and adjustments.
Use clean, fresh, unleaded gasoline with an octane rating of at least 87. Avoid ethanol blends higher than 10%, as they can cause damage to the engine components.
Before storing for winter, clean the tractor thoroughly and change the oil. Add a fuel stabilizer to the tank and run the engine for a few minutes to distribute it. Remove the battery and store it in a cool, dry place. Cover the tractor to protect it from dust and moisture.
To improve traction, consider using tire chains or weights. Ensure tires are properly inflated for the conditions and use a lower gear when operating on slippery surfaces. Adding ballast to the rear of the tractor can also help in improving traction.
If the PTO does not engage, check the PTO switch and connections for any damage or dirt. Ensure that the belt is properly tensioned and not worn out. Inspect the PTO clutch and refer to the manual for specific troubleshooting steps.
To replace the drive belt, first disconnect the spark plug wire. Remove the mower deck and locate the belt. Release the belt tension and remove the old belt. Install the new belt, ensuring it is properly seated on all pulleys. Reassemble the deck and reconnect the spark plug wire.