Simplicity 1695109 Regent Parts Manual
![Simplicity 1695109 Regent Tractor manual cover](/images/iXQIUJibEYMzFiOIgXmrxJdf/thumbs/thumb175x175.webp)
To change the oil, first run the engine for a few minutes to warm it up, then shut it off. Place a pan under the engine, remove the oil drain plug, and let the old oil drain completely. Replace the drain plug, then refill with the recommended oil type and capacity as per the manual.
Check the battery connections to ensure they are clean and tight. Verify that the fuel tank has fresh gasoline. Ensure the spark plug is clean and functional. If the problem persists, consult the manual for further troubleshooting steps or contact a professional technician.
To adjust the cutting height, locate the height adjustment lever on the side of the tractor. Move the lever to the desired position, adjusting the deck height from 1.5 to 4 inches according to your preference and grass conditions.
After each use, clean the mower deck by using a garden hose to remove grass clippings and debris. For a thorough cleaning, safely lift the mower and use a scraper to remove any stuck-on grass. Ensure the tractor is off and cool before cleaning.
Mower blades should be sharpened twice per mowing season or more frequently if you notice uneven grass cutting or excessive vibration. Always remove the blades for sharpening and balance them before reinstalling.
At the start of each season, perform a full inspection including changing the oil, checking the air filter, inspecting the spark plug, greasing the fittings, and checking tire pressure. Review the operator's manual for specific maintenance instructions.
An overheating engine can be due to a clogged air filter, low oil levels, or debris around the engine cooling fins. Check and clean these components as necessary and ensure proper ventilation around the engine compartment.
First, ensure the tractor is off and the spark plug is disconnected. Remove the mower deck and any obstructing covers. Release tension from the belt tensioner and remove the old belt. Install the new belt following the belt routing diagram in the manual and reassemble the components.
Uneven cutting can be caused by a misaligned mower deck, dull blades, or tire pressure discrepancies. Check and adjust the deck alignment, ensure blades are sharp, and maintain even tire pressure for optimal performance.
To store the tractor for winter, clean it thoroughly, change the oil, and add a fuel stabilizer to the gasoline. Disconnect the battery and store it in a cool, dry place. Cover the tractor to protect it from dust and moisture.