Simplicity 1693758 Broadmoor Parts Manual
![Simplicity 1693758 Broadmoor Tractor manual cover](/images/LzQieYjfKbXotmqqkkrGLimO/thumbs/thumb175x175.webp)
To change the oil in your Simplicity 1693758 Broadmoor Tractor, first ensure the engine is cool. Locate the oil drain valve under the engine, place an oil pan beneath it, and open the valve to drain the old oil. Replace the oil filter, close the drain valve, and refill with the recommended oil type and quantity as specified in the owner's manual.
If your Broadmoor Tractor won't start, check the battery connections for corrosion and ensure they are tight. Verify that the fuel tank has fresh fuel and that the fuel shut-off valve is open. Inspect the spark plug for wear and replace if necessary. Also, make sure the PTO (Power Take-Off) is disengaged and the parking brake is set.
To adjust the cutting height of the mower deck on the Simplicity Broadmoor Tractor, locate the height adjustment lever, usually positioned near the driver's seat. Move the lever to the desired position to raise or lower the deck. Make sure the tractor is on a level surface to ensure an even cut.
Before storing the tractor for the winter, clean the exterior and mower deck to remove grass clippings and debris. Change the oil and filter, and drain the fuel system or add a fuel stabilizer. Remove the battery and store it in a cool, dry place. Inflate the tires to the recommended pressure and cover the tractor to protect it from dust and moisture.
If your mower is cutting unevenly, check that the tire pressures are equal on all sides. Inspect the mower blades for sharpness and replace or sharpen them if needed. Ensure the mower deck is leveled correctly by measuring from the ground to the deck on each side and adjusting as necessary.
The Simplicity 1693758 Broadmoor Tractor is designed to run on unleaded gasoline with an octane rating of 87 or higher. Avoid using ethanol blends greater than 10% to prevent engine damage. Always refer to the owner's manual for specific fuel recommendations.
The frequency of sharpening mower blades depends on usage, but a general guideline is to sharpen them after every 20-25 hours of operation. Regularly inspect the blades for nicks or dullness and sharpen or replace them to maintain optimal cutting performance.
To clean the air filter on your Broadmoor Tractor, remove the filter cover and take out the air filter. If it's a foam filter, wash it with warm, soapy water, rinse thoroughly, and allow it to dry completely before reinstalling. For paper filters, gently tap them to remove dust or replace them if they are too dirty or damaged.
Excessive vibration can be caused by unbalanced or damaged mower blades, loose hardware, or engine issues. Check the blades for damage or imbalance and replace or balance them as needed. Ensure all nuts and bolts are tightened and inspect the engine mounts for wear or damage.
To replace the drive belt, first disconnect the spark plug to prevent accidental starting. Remove the mower deck according to the manual instructions. Locate the belt and release the tension by adjusting the tensioner pulley. Remove the old belt and install the new one, ensuring it is routed correctly around all pulleys. Reattach the mower deck and reconnect the spark plug.