Simplicity 1693610 Broadmoor Parts Manual
![Simplicity 1693610 Broadmoor Tractor manual cover](/images/yNSJBbVRUSURmEeYmqWkwtkO/thumbs/thumb175x175.webp)
To change the oil, first run the engine for a few minutes to warm it up. Then, turn off the engine and place a container under the drain plug. Remove the drain plug and allow the oil to completely drain. Replace the drain plug and refill with the recommended type and amount of oil.
If your tractor won't start, check the battery connections for corrosion and ensure they are tight. Verify that the fuel level is adequate and the fuel is fresh. Inspect the spark plugs and air filter for cleanliness. If the issue persists, consult the manual or contact a service professional.
To level the mower deck, park the tractor on a flat surface. Measure the height of the deck from the ground on both sides. Adjust the deck links until both sides are equal. Refer to the manual for detailed adjustment procedures.
Regular maintenance includes checking the oil level before each use, changing the oil every 50 hours, inspecting the air filter every 25 hours, and replacing it as needed. Sharpen or replace mower blades annually or as required. Consult the manual for a complete schedule.
To replace the drive belt, first disengage the mower deck and remove it. Locate the belt routing diagram for reference. Remove the old belt and install the new one following the diagram. Reattach the mower deck and ensure the belt is properly aligned and tensioned.
Engine overheating can be caused by low coolant levels, a blocked cooling system, or a faulty thermostat. Check the coolant reservoir and refill if necessary. Clean any debris from the radiator and cooling fins. If the problem continues, have the thermostat checked by a professional.
Use unleaded gasoline with a minimum octane rating of 87. Avoid fuel with more than 10% ethanol content as it may damage the engine. Store fuel in clean and approved containers to prevent contamination.
To clean the air filter, remove the cover and take out the filter. If it is a paper filter, tap it gently to remove dust, or replace it if it is too dirty. For foam filters, wash with warm soapy water, rinse, and let it dry completely before reinstalling.
If the mower blades do not engage, check the PTO switch and ensure it is in the correct position. Inspect the belts for wear or damage and replace if necessary. Ensure that all safety interlocks are functioning correctly.
To winterize your tractor, clean it thoroughly and remove any grass clippings. Change the oil and filter, and fill up the fuel tank with treated fuel. Disconnect the battery and store it in a cool, dry place. Cover the tractor to protect it from dust and moisture.