Simplicity 1693601 Broadmoor Parts Manual
![Simplicity 1693601 Broadmoor Tractor manual cover](/images/WamTSBERXrHDmJmMJyQIUANg/thumbs/thumb175x175.webp)
To engage the mower deck, first ensure the tractor is on a flat surface. Start the engine and set the throttle to the mid-to-high range. Pull the PTO switch upward to engage the mower deck. Make sure the blades are clear of obstacles before engaging.
It is recommended to use SAE 10W-30 oil for most operating temperatures. Always check your owner’s manual for specifics and ensure the oil meets the API service classification SF, SG, SH, SJ, or higher.
If the tractor won't start, check the battery connections and ensure they are clean and tight. Verify that the fuel valve is open and there is sufficient fuel in the tank. Inspect the spark plug for wear and replace it if necessary. Ensure the brake pedal is fully depressed when starting.
The air filter should be checked before each use and replaced every 25 operating hours or at least once a season. Operating in dusty conditions may require more frequent changes.
First, ensure the PTO switch is in the 'ON' position and the engine is running at full throttle. Check the drive belt for wear or damage and replace if necessary. Inspect the PTO clutch for proper function and adjust or replace it if needed.
To adjust the cutting height, locate the cutting height adjustment lever next to the driver's seat. Move the lever to the desired position to raise or lower the deck. For uniform cutting, ensure all four corners of the deck are set to the same height.
Before storing the tractor, clean the exterior and mower deck thoroughly. Change the oil and replace the oil filter. Stabilize the fuel or drain the fuel tank. Remove the battery and store it in a cool, dry place. Lubricate all moving parts.
For improved traction on slopes, consider using tire chains and adding rear wheel weights. Always mow up and down slopes, not across, and reduce speed to maintain control.
Check the steering linkage and tie rods for wear or damage. Ensure that all bolts and nuts are tightened securely. Inspect the front wheel alignment and adjust if necessary. Lubricate steering components to ensure smooth operation.
To change the spark plug, first disconnect the spark plug wire. Use a spark plug socket to remove the old plug. Check the gap on the new spark plug and adjust if necessary. Install the new plug by hand to avoid cross-threading, then tighten with a socket. Reconnect the spark plug wire.