Simplicity 1693452 Express Parts Manual

To start the Simplicity 1693452 Express Tractor, ensure the parking brake is engaged, the PTO is disengaged, and the throttle is set to the 'start' position. Turn the ignition key to the 'start' position and release once the engine starts.
If the engine won't start, check the battery connections for corrosion, ensure there's enough fuel, and verify that the spark plug is functioning. Consult the manual for further troubleshooting steps.
It is recommended to change the oil every 50 hours of operation or at the start of each season, whichever comes first. Always use the oil type specified in the owner's manual.
To replace the drive belt, first disconnect the spark plug wire to ensure safety. Then, remove the mower deck, release the belt tension, and replace the old belt with a new one following the diagram in the manual. Reassemble all parts accordingly.
Use unleaded gasoline with a minimum octane rating of 87. Avoid using ethanol blends higher than 10% as they can damage the engine.
To adjust the cutting height, locate the height adjustment lever on the tractor. Move the lever to the desired cutting height position. Ensure the mower is on a flat surface for an accurate adjustment.
Excessive vibration may be caused by debris in the mower deck, unbalanced blades, or loose parts. Check and clean the mower deck, inspect the blades for damage or imbalance, and tighten any loose fasteners.
To maintain the battery, keep it clean and dry, and check the terminals regularly for corrosion. Charge the battery fully before storage, and disconnect it if storing the tractor for an extended period.
Clean the tractor thoroughly, remove the mower deck, and perform all recommended maintenance. Store the tractor in a dry, sheltered area, and disconnect the battery. Add a fuel stabilizer to the fuel tank to prevent degradation.
Uneven cutting may be due to improperly inflated tires, a misaligned deck, or dull blades. Check tire pressure, level the mower deck according to the manual, and sharpen or replace blades as needed.