Simplicity 1693255 Landlord Parts Manual
![Simplicity 1693255 Landlord Tractor manual cover](/images/UxiCqnkTgddqNKWNVgLUIZLy/thumbs/thumb175x175.webp)
To change the oil, first run the engine for a few minutes to warm it up. Turn off the engine and disconnect the spark plug. Place a container under the oil drain valve, open it, and let the old oil drain completely. Replace the oil filter if necessary. Close the valve and refill with the recommended type and amount of oil. Check the oil level with the dipstick.
Check the battery to ensure it is charged and the connections are clean and tight. Ensure the fuel tank has adequate fuel and the fuel valve is open. Inspect the spark plug for wear or damage, and replace it if necessary. Make sure the choke is properly set and the air filter is clean.
Locate the cutting height adjustment lever, usually found on the fender or near the seat. Move the lever to the desired cutting height position. Make sure the tractor is on a level surface and the engine is off while making adjustments.
Check the PTO (Power Take-Off) switch to ensure it is in the 'on' position. Inspect the drive belts for wear or damage and replace them if necessary. Ensure that the safety switches are functioning correctly and that there are no obstructions under the deck.
Perform regular maintenance at the start and end of each mowing season. This includes checking the oil level, inspecting the air filter, sharpening the blades, and checking the tire pressure. Refer to the owner's manual for a detailed maintenance schedule.
Ensure the tires are properly inflated according to the specifications. Add wheel weights or fill tires with ballast to increase traction. Always mow up and down slopes, not across them, and avoid sharp turns on slopes to maintain stability.
Use fresh, clean, unleaded gasoline with an octane rating of 87 or higher. Avoid gasoline containing more than 10% ethanol, as it can damage the engine components.
Disconnect the spark plug and lower the deck. Remove the old belt by releasing tension from the idler pulley. Install the new belt, following the routing pattern indicated in the owner's manual. Ensure the belt is seated properly in all pulleys before re-tensioning.
Excessive vibration could be due to unbalanced or damaged blades. Check for bent blades and replace them if necessary. Inspect the drive belt for wear or misalignment. Ensure all mounting bolts and nuts are tight and secure.
To winterize, clean the mower deck and remove any grass clippings. Drain the fuel system or add a fuel stabilizer to prevent fuel degradation. Change the oil and oil filter. Store the tractor in a dry, covered area and disconnect the battery to prevent drainage.