Simplicity 1691014 7112 Parts Manual
![Simplicity 1691014 7112 Tractor manual cover](/images/nyLalqdpqRKSlHbZMDRrcQfs/thumbs/thumb175x175.webp)
To start the Simplicity 1691014 7112 Tractor, ensure the parking brake is engaged, the PTO is disengaged, and the throttle is set to the choke position. Turn the ignition key to the start position until the engine starts, then release the key to the run position.
The Simplicity 1691014 7112 Tractor typically requires SAE 30 oil for temperatures above 32°F (0°C) and SAE 5W-30 for temperatures below 32°F (0°C). Always check the owner's manual for specific recommendations.
If the engine does not start, check the fuel level, ensure the spark plug is clean and properly connected, and verify that the battery is charged. Also, make sure the safety switches are not engaged.
It is recommended to change the oil every 50 hours of operation or at the beginning of each season, whichever comes first. Always refer to the owner's manual for specific maintenance intervals.
Check to ensure that the mower deck is level and that the blades are sharp and not damaged. Adjust the tire pressure to ensure even weight distribution and inspect for any obstructions in the deck.
To maintain the battery, keep the terminals clean and free from corrosion. Ensure the battery is fully charged before storing the tractor for extended periods, and check the electrolyte level regularly if applicable.
To winterize the tractor, clean the exterior, change the oil, and run the engine until the fuel system is dry. Remove the battery and store it in a cool, dry place. Cover the tractor to protect it from dust and moisture.
To adjust the mower deck height, locate the lever or knob on the tractor designated for deck height adjustment. Move it to the desired position, ensuring both sides are adjusted equally for an even cut.
Common reasons for overheating include low coolant levels, a clogged air filter, or blocked engine cooling fins. Regularly inspect and clean these components to ensure proper engine cooling.
To replace the drive belt, first disconnect the spark plug and remove the mower deck. Locate the belt path and release tension from the idler pulleys. Remove the old belt and install the new one, ensuring it is routed correctly. Reassemble the components and test the operation.